Vehicle Platform & ECU Name DTC Troubleshooting Data Ver: 1.0 Date: 30/11/2019 Author: ERC Page 41 of 610 Copyright by TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without our consent P0562- 16- System Voltage Low Overview: Code Cause Effect on Vehicle Fault Code: P0562-16 1. Battery is discharged fully 2. Battery terminals are damaged 3. Wiring harness discontinuity CE lamp ON Performance deterioration on vehicle. Checkpoints: 1. Check Battery Voltage at key on (min 11 V) Trouble Shooting Steps: Sr. No. Steps Specifications Step 1 Check the battery voltage with the ignition switch on. If the voltage is too low then recharge the battery Min 11 V Step 2 Check whether the battery terminal's are connected properly and they are tight. If not proper do the necessary repair Proper connection Step 3 Check ECU connection: 1] Key off 2] Remove the ECU 3] Connect ECU connector Properly 4] Key on and Read the faults Step 4 Check the charging circuit. In case of any problems in charging do the necessary repair Step 5 If problem still persists; Replace the ECU. Circuit Description: The battery supplies electricity to ECM even when the ignition switch is OFF. This electricity allows ECM to store data such as DTC history, freeze frame data, fuel trim values and other data. If the battery voltage falls out of range, ECM will conclude that there is a fault in the power supply circuit. Circuit Schematic Diagram: Component location and image:
RkJQdWJsaXNoZXIy MTIwNTUz