Dry these parts with compressed air before assembly to keep alcohol out of the system. Replace all rubber parts in the system including hoses. Also when working on the brake mechanisms, check for fluid on the linings. If excessive fluid is found, replace the linings. If master cylinder piston seals are satisfactory, check for leakage or excessive heat conditions. If condition is not found drain fluid, flush with brake, refill and bleed the system. The system must be flushed inferior quality fluid is found in the system. 5. ROAD TESTING a. Road test for the brakes shall be taken by the skilled driver with sufficient experience. b. Brakes shall be tested on dry, clean smooth and reasonably level road that is not crowded. c. Drive the vehicle at low speeds in a safe area. d.Test the brakes by making brake applications with both light and heavy pedal forces at various speeds to determine if the car stops evenly and effectively. e. If required carry out wheel balancing and alignment. BRAKES 37
RkJQdWJsaXNoZXIy MTIwNTUz