Vehicle Platform: Nexon-EV ,Nexon-MCE ECU Name: Telematics Control Unit (TCU) DTC Troubleshooting Data Version: 1.4 Date: 16-09-2020 Author: TCM COC Page: 50 of 121 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. U0140 - 08 :- Lost Communication With Body Control Module - Bus Signal / Message Failures Overview: ISO Code U0140 – 08 Lost Communication With Body Control Module - Bus Signal / Message Failures Customer Symptom Following Telematics features will not be working:- Remote Lock/Unlock, Remote Lights on/off, Remote climate/HVAC control, Remote charging On/Off, Unauthorized Car Access Alert - Intrusion Alert, Alerts about critical car parameters (Including battery related alerts),View Trip details and Provide drive pattern analytics with Driver Score (Should be sharable on social media),EV range prediction - VCU Calculated, View Car Health Dashboard, Remote Horn, Panic Notification Fault Effects (On Vehicle) Remote , Vehicle security, Alerts and other telematics features will not be working Fault Detection Condition Relevant functional DTCs present in TCU .DTC is set in case of Lost Communication With BCM Module Normal Operating Condition BCM ECU communicates properly with TCU in normal condition. Probable Trouble Area CAN_H and CAN_L wires CAN transceiver faulty Faulty BCM ECU The TCU has detected a communication problem on the CAN regarding the BCM Module CAN high / CAN low pins shorted to Battery/Open/ shorted to Ground CAN transceiver faulty DTC is to be logged when the subscribed message is not available on the CAN bus from BCM module Healing Condition 1. Verify DTC ageing-Clear in case of ageing 2. Verify BCM DTCs and check for any related DTCs 3. Follow BCM trouble shooting guideline 4. Check CAN H and CAN L connections for short/open 5. Check for CAN transceiver faulty ,if it is fault then replace 6. Power down the device, power up again and wait for at least one minute. If the problem reoccurs, check whether any other CAN-related DTCs are set in the TCU. In that case, check for problems with the CAN hardware (TCU and bus) 7. Clear the DTC 8. If problem persists after above steps (from 1 to 7) then follow BCM ECU DTC trouble shooting guide
RkJQdWJsaXNoZXIy MTIwNTUz