NEXON 3.0 EV DTC Troubleshooting Document for VCU Version: 2.0 Date: 22-Sep-2023 Copyright © TATA MOTORS Ltd. This document must not be used in anyway, such as copying and redistributing to third parties, without the consent of author. 6 If there are any inline connectors, remove each of them Check if there is continuity between consecutive connector’s pin CAN H and CAN L Problem is in 3in1 to VCU wiring harness inline connectors Action: Change 3in1 to VCU inline wiring harness No problem in wiring between the inline connectors Go to Step 7 7 Remove the LV connector of VECU Check if there is continuity between VECU side connector pin CAN H and CAN L Check for damage in VECU connector Action: Replace VECU side connector No problem in VECU side LV connector Go to step 8. 8 Remove the LV connector of VECU Check if there is continuity between pin CAN H and CAN L of VECU Check for damage in VECU pin Action: Replace VECU Go to step 9 Go to step 9 9 Remove the 12V LV battery negative terminal. After a minute connect the 12V LV battery negative terminal & "Ignition Switch" to ON position. Crank and wait for 2 minutes. Check for the fault code. Fault code U1329-08 is present? Go to step 10 Repair complete. 10 Remove the LV connector of 3in1 C813 Check if there is continuity between 3in1 signal connector C813 pin 5 (CAN H) and VCU connector C776B pin 101. 3in1 signal connector C813 pin 6 (CAN L) and VCU connector C776B pin 102. Problem in DC-DC Converter, replace it Check for damage in connector pin/LV harness Action: Replace the pins/ terminals or LV harness and go to step 1
RkJQdWJsaXNoZXIy MTIwNTUz