Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Vehicle Platform: F4 (Bolt) / F5 ( Zest) / TIAGO / TIGOR / EAGLE/OSPREY/Q5/X451 ECU Name: Hella Body Control Module (BCM) ECU Replacement Procedure Version: 3.9 Date: 09-June-2022 Author: BCM CoC Page: 18 of 39 d. Send service request Tester Present. (Send service request $3E 00) e. Before writing check whether AES_SK is locked for writing or not, send service request: ($22 42 23) and read the response. If response is ‘01’ i.e. 62 42 23 01 then unlocking of AES_SK is required before writing. Else if response is ‘00’ i.e. 62 42 23 00 then start writing AES_SK key immediately. f. To write AES_SK code, Send service request: ($2E 42 22 XXXX). XXXX - This represents 16 bytes AES_SK value which is to be written in the ECU. g. Get Tool generated ASK-Key value as per VIN number and write into DID 4222, Send service request: ($2E 42 22 XXXX). Note: - Just compare once ASK-key value with EMS once as it is same. h. Select “Replacement” main option from TDS Tool. Perform the parameterization as per vehicle variant with the help of diagnostic tool. i. Select “IMMO Transponder Key Learning” option from Routine Test main option. Read and verify that LIN IMMO Function is enabled using DID 444C value as 0x01. j. Check Odometer value as less than 250KM, then execute steps from “next i.e. k” for Auto Key pairing for IMMO, else if odometer value is equal and greater than 250KM then jump to step number “p” for Diagnostic routine Key pairing for IMMO. k. Give ECU reset (Diagnostics Request) ($11 01). Wait for 1 sec after reset. l. After hard reset the 1st key inside the barrel will be auto paired, while LIN IMMO Function is enabled. m. Read status for number of keys paired with IMMO from DID 443B as 0x01. n. Remove the 1st key from key barrel. Insert the 2nd key into barrel and keep the key position in Accessory. Wait for 2 sec and turn Ignition ON. Note: - Do not insert the 1st paired key again into the barrel. Insert the 2nd key into barrel within 20 sec from the 1st key removal. o. Read status for number of keys paired with IMMO from DID 443B as 0x02. Jump to step number “x”. Don’t execute following steps. p. Read status for number of keys paired with IMMO from DID 443B. If DID 443B value is 0x00 or 0x01, then jump to step number “q”. If DID 443B value is 0x02, then show “2 keys are already pair with BCM. Hence current keys could not able to pair” message over tool screen and jump to step number “ee” q. Send service request for start erase previous learned keys routine $ 31 01 4F 0D 0A. r. Check Start routine response of the routine (71 01 4F 0D XX YY). Where XX = Status of Routine. 00 – BCMLifeCycleTransponderKey is blank, 01 – BCMLifeCycleTransponderKey is not blank.
RkJQdWJsaXNoZXIy MTIwNTUz