TML Gen3 IVI DTC Troubleshooting guide Version: 0.4 Draft Date: 04-Aug-23 Author: Hemant Mitra Page: 438 of 584 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Trouble Shooting:- Turn ON Ignition. Connect the TML Diagnostic Tool. Check the status of DTC’s (Memorized/Current) Record the DTC & Clear DTC’s Turn Ignition OFF & ON Verify If DTC B1949 -11 is present Is DTC B1949-11 is Present? Check for continuity between Connector A, Pin No. 8 (GND) & Connector C, Pin no.23 (FLS input) of ECU side. Is Continuity Present? FLS input is Short Circuit to Ground. Rectify Fault at wiring Harness & wait for 20sec to recover the fault. Clear the DTC & check the change in fuel level in Fuel bars. Clear the DTC from the ECU memory. Turn Ignition OFF & ON. Check the change of fuel level in Fuel bars. Stop Stop YES NO YES NO Stop
RkJQdWJsaXNoZXIy MTIwNTUz