ERC, Chassis Engineering Prepared by : Sagar K Approved by: Bhavesh Raut Page | 119 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Nexon MCE ESP DTC Troubleshooting data Document no: X01ME111219 Date: 11-Dec-19 U0484 - 81:- Invalid Data Received From Transmission Control Unit Overview: ISO Code U0484-81 Customer Symptom Warning light Displayed Fault Effects (On Vehicle) ABS, EBD – Available, ESP, HHC & HDC- Availability depends on fault type Lamp Status (If Any) ABS – OFF, EBD – OFF, ESP, HHC & HDC– ON(depends on fault type) Fault Detection Condition Incorrect data received from TCU ECU Normal Operating Condition TCU ECU sends correct data in normal condition. Probable Trouble Area TCU ECU and its interface circuits and sensors Healing Condition After rectifying all the functional failures in the TCU ECU. Preliminary Check: 1. Check resistance in Diagnostic CAN pin no. 8 and 9. It should be 120 Ω. 2. Check for short conditions between CAN_H (pin no. 14)-CAN_L (pin no.2), CAN_H (pin no. 14)-GND (pin no. 13), CAN_L (pin no. 2)-GND (pin no. 13), CAN_H (pin no. 14)-Vbatt (pin no. 1) and CAN_L (pin no. 2)-GND (pin no.13). There should not be any short circuit conditions. 3. Read IVN DTCs in ABS/ESP in IGN ON condition Note: After rectification please give Ignition latch to heal the DTC.
RkJQdWJsaXNoZXIy MTIwNTUz