TATA MOTORS LTD. V2X charging- Standard operating Procedure In Vehicle Ignition OFF mode Project: Kanger3 Rev. V1.0 Date:09/08/23 Controlled copy for restricted circulation © TATA MOTORS LTD Format No: 8. Press V2X switch with in 120sec of step 4 to start 220V AC power supply from vehicle. If user couldn’t press V2X switch within 120sec of step 3. Remove the Gun completely and repeat from step 3 to initiate the V2L function. 9. Ensure safety precaution against the live 220VAC voltage in the V2L adaptor 10. Turn on the loads. 11.Check telltale indication in instrument cluster to ensure V2L discharging is initiated/in progress 12.Check for the telltale indication frequently when the V2L discharge function is in progress to ensure there is no interruption/fault. 13.V2L function will stop if there is no energy dissipation has happened/if there is no load is connected for 100secs from successful step 8. In this case, remove the gun completely and start from step 3 to reinitiate the V2L discharge function 14.To stop the V2L discharge function, First switch off the external loads and then press V2X switch second time to disable the 220V AC power supply and Go to step 17. 15.V2L function will automatically stops if the source vehicle SOC goes below the user set value or at the default value of 30%. In that case go to step 17 16. In case V2L function gets interrupted from vehicle side due to any fault, Press the Gun unlock fascia switch in vehicle and completely remove the gun repeat from step 3 If the issue still remains, Press the Gun unlock fascia and completely remove the gun. Keep the vehicles in Ignition OFF state for 120sec. Then repeat from Step 3. If the charging get interrupted again from vehicle side go to step 17 and vehicle along with the V2L adaptor need to be taken to nearby TATA service station 17.Switch off and remove the Connected Loads then Press Fascia switch and remove the V2L adaptor. (Close the V2L adaptor caps to ensure it is not exposed to mud/metal particle etc).
RkJQdWJsaXNoZXIy MTIwNTUz