TATA BSVI Gasoline_Bifuel Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.9 Date: 24-01-2022 Prepared By: Veer K. Singh / Prudhvi B Varma Checked By: Yeshwant Jadhav Approved By: Sanjeev M. Document Part No: 2921 02 xxx xxxx Page: 1203 of 1692 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Flow Chart: - START Is there wiring harness electrical continuity between ECU pin 129 & alternator signal pin.& Auto Start Stop LED Lamp indicatorcontinuity between ECU pin 130 & Auto Start Stop LED Lamp indicator Establish continuity by rectifying harness connections as per the circuit diagram It is ok? Maintain sufficient coolant level It is ok? Check temperature sensor connections It is ok? Rectify /replace connector It is ok? Check for damage of Alternator control connector. END Rectify wiring harness Maintain sufficient Check for regulator connections It is ok? Check if coolant level low Repair the connections as per the schematic Fault still persists then Replace the EMS ECU It is ok?
RkJQdWJsaXNoZXIy MTIwNTUz