TATA BSVI Gasoline_Bifuel Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.9 Date: 24-01-2022 Prepared By: Veer K. Singh / Prudhvi B Varma Checked By: Yeshwant Jadhav Approved By: Sanjeev M. Document Part No: 2921 02 xxx xxxx Page: 1520 of 1692 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P1607-11: CNG lamp min error Overview: ISO Code P1607-11 Customer Symptom CNG Facia switch Lamp will be always ON irrespective of selected fuel mode Fault Effects (On Vehicle) No Symptoms observed Lamp Status (If Any) No Lamp Indication Fault Detection Condition This fault gets logged when Lamp pin no.128 is shorted to Ground, or Wiring Harness problem and vehicle is in Gasoline Fuel mode Normal Operating Condition Healthy Wiring Harness connections between CNG Lamp and EMS ECU Probable Trouble Area Wiring Harness Connections, Lamp switch, ECU Healing Condition After 1 drive cycles in CNG Mode fault is healed Fault present deletion 1. Clear DTC Command form Scan tool 2. Stack Over Flow. 3. 40 warm up cycles. 4.ECU flashing 5. ECU power fail Component Details: This lamp indicates selected fuel mode through fuel mode selector facia switch. This lamp will turn ON once the CNG fuel mode is selected. This lamp will remain OFF when you select petrol fuel mode. Preliminary Checks: 1. Check for the proper connection of connector to the LED. 2. Check wiring harness 3. Change the lamp
RkJQdWJsaXNoZXIy MTIwNTUz