TATA BSVI Gasoline_Bifuel Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.9 Date: 24-01-2022 Prepared By: Veer K. Singh / Prudhvi B Varma Checked By: Yeshwant Jadhav Approved By: Sanjeev M. Document Part No: 2921 02 xxx xxxx Page: 1525 of 1692 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Trouble Shooting:- Step Checks IF YES IF NO 1. Check the Lamp Switch for any damage Replace Lamp switch Go to step 2 2. Is there any dirt or Rust on Connector Remove the connector and clean it and refit it tightly Go to Step 3 3. IS the EMS ECU pin 128 short to Open. Rectifying wiring harness connections as per the schematic. Go to Step 4 4. Check the continuity between the EMS ECU pin 128 and CNG Led pin. Go to step 5 Establish continuity by rectifying wiring harness connections as per the schematic. 5. Fault Still Persists? Replace the switch Go to step 6 6. Fault Still Persists? Fault still persists then Replace EMS ecu Follow the steps again for reconfirmation DTC’s confirmation:- Recheck the fault, fault shall not reappear
RkJQdWJsaXNoZXIy MTIwNTUz