Vehicle Platform & ECU Name DTC Troubleshooting Data Ver: 1 Date: 23/11/2022 Author: ERC Page 174 of 834 Copyright by TATA MOTORS Ltd. This document must not be used in any w ay, such as copying and redistributing to third parties, w ithout our consent P04FD- 52: EGR Actuator "A" Control Processor Performance Enable Pin Overview: Code Cause Effect on Vehicle Fault Code: P04FD-52 1. ECU connector loose connection 2. ECU hardware malfunction 1.CE Lamp ON 2.Higher engine noise may be observed Lamp status: Check Engine Lamp on Malfunction Indicator Lamp off Checkpoints: Check battery voltage at Ignition off (Nominal range – 11.5V to 12.8 V) Trouble Shooting Steps: Sr. No. Steps Specifications Step 1 Check whether the ECU connector connected properly - Step 2 Check all the sensor connectors are connected properly & working correctly - Step 3 If the problem persists, replace the ECU - Verification condition: Drive the vehicle in city and highway condition. Circuit Description: ECM continuously monitors its internal memory status, internal circuits. These are basically self-checks that ensure that ECM is functioning properly. If any malfunction is detected, ECM will set the DTC. ECM is supplied voltage from the battery positive supply through Main relay. ECM ground connection is connected to the battery negative supply. ECM functionality critically depends on ensuring proper ground connection.
RkJQdWJsaXNoZXIy MTIwNTUz