Vehicle Platform & ECU Name DTC Troubleshooting Data Ver: 1 Date: 23/11/2022 Author: ERC Page 423 of 834 Copyright by TATA MOTORS Ltd. This document must not be used in any w ay, such as copying and redistributing to third parties, w ithout our consent Associated Parameters: Parameter Label Description DID Monitoring Main injection fuel demand chkd Main injection fuel demand. FE65 Ranges from 1 mg/st to 55 mg/st based on engine load IMV current demand IMV current demanded by the ECU FE14 “IMV current demand” and “Measured current in the IMV actuator” closely matches in normal operation. Measured current in the IMV actuator IMV current feedback to the ECU FE61 State of the rail pressure control State of the rail pressure control FE63 Rail pressure control state to be noted Rail pressure error Rail pressure error FE20 Error should be less than 100 bar for normal operation Rail pressure feedback Rail pressure sensor feedback FE1 A Rail pressure feedback to be noted Verification condition: Drive the vehicle in city and highway condition for 20 mins. Component Details: Inlet Metering Unit (IMV) is used to control pressure inside the rail. The IMV delivers metered fuel quantity to high pressure pump. High-pressure pump delivers fuel to common rail. The IMV governing is done by ECU based on the demand to maintain the required rail pressure. The Rail Pressure Sensor is used to determine the actual rail pressure. That value is needed for high-pressure control, engine protection and injection control. The sensor is mounted on the rail. Circuit Schematic Diagram:
RkJQdWJsaXNoZXIy MTIwNTUz