Vehicle Platform & ECU Name DTC Troubleshooting Data Ver: 1 Date: 23/11/2022 Author: ERC Page 648 of 834 Copyright by TATA MOTORS Ltd. This document must not be used in any w ay, such as copying and redistributing to third parties, w ithout our consent Trouble Shooting: Start Read IVN DTCs in ECM Is MTO logged against TCM in ECM in current state ? No (In history) 1. Check continuity between ECM CAN_H to TCM CAN_H and ECM CAN_L to TCM CAN_L in vehicle wiring side connector. 2. Check if TCM ECU fuses are blown. 3. Also, check TCM ECU is powered up properly. TCM Battery, IGN and GND connected properly with TCM ECU. Is continuity there? Repair the wiring harness if continuity is not there Clear DTC Stop Yes Yes No U0101-31: Lost of communication with Transmission Control Module- Bus Signal/Message Failure Check the continuity between ECM CAN_L & IPC CAN_L And ECM CAN_H & IPC CAN_H In vehicle side connectors Check the resistance between ECM CANH and ECM CANL of ECM connector in vehicle wiring harness. (with IPC connected on the vehicle) Is Resistance R = 120 ohm ? No Yes
RkJQdWJsaXNoZXIy MTIwNTUz