NEXON AMT BS VI DTC Troubleshooting Guide Version: 2.3 Date: 23-07-2019 Author: Rahul N Page: 234 of 442 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. DTC P0710-02), are sensor connections OK? operation (refer DTC P0710-04). 6 Clear the DTC and drive the vehicle through all gears for 10 kms. Key OFF, repeat this cycle 5 times. Is the fault recurring? Replace clutch Release vehicle to the customer after final drive test DTC’s confirmation:- After rectification, clear all DTC’s and ensure the following points by referring TCU parameters using TML diagnostic tool before handing over to customer. • Pickup the vehicle to 20 Kmph under heavy throttle (>50%), and decelerate to standstill, do this for 10 cycles and monitor the clutch temperature and ensure it is less than xyz. • Drive the vehicle through all gears in both Automatic and Manual modes • Ensure no DTC is active and Transmission Fault Lamp is OFF. Circuit Schematic Diagram:
RkJQdWJsaXNoZXIy MTIwNTUz