NEXON NEW MCE-2 DCT BS VI DTC Troubleshooting Guide Version: 1.0 Date: 16-06-2023 Author: Akash/Rahul Page:29 of 645 Copyright ©TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. 3 If the issue persists, swap the TCU & flash the adaption data from the previous TCU. Clear the DTC & check if the DTC becomes active again. Go to step 4 4 If the fault is still active, replace the Angle Sensor. Clear the DTC & check if the DTC becomes active again. Go to step 5 5 If the fault is still active, replace the drum motor. Clear the DTC & check if the DTC becomes active again. Go to step 6 6 If the fault is available, replace hydraulic block containing the pressure sensor. Perform necessary adaption Clear the DTC & check if the DTC becomes active again. DTC’s confirmation:- After rectification, clear all DTC’s and ensure the following points by referring TCU parameters using TML diagnostic tool before handing over to customer. • Drive the vehicle through all gears in both Automatic and Manual modes. • Ensure no DTC is active and Transmission Fault Lamp is OFF. Circuit Schematic Diagram: Component Location & Image:-
RkJQdWJsaXNoZXIy MTIwNTUz