NEXON NEW MCE-2 DCT BS VI DTC Troubleshooting Guide Version: 1.0 Date: 16-06-2023 Author: Akash/Rahul Page:85 of 645 Copyright ©TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. ➢ Disconnect connector (X-201) and check below resistance at (X-201) connector terminal on TCU PIN 10 (Sump temperature ) Sump temperature (°C) Sensor resistance (Ω) Component check > 110000 open Sump temperature sensor is malfunctioning -40 to 0 105000 to 14000 ok 0 to 30 14000 to 4000 ok 30 to 50 4000 to 2000 ok 50 to 100 2000 to 470 ok 100 to 150 470 to 130 ok < 130 short ➢ Disconnect connector (X-201), disconnect transmission circular connector (X-111) and check below resistance at transmission circular connector pins. Measure Resistance (Ω) Component check Pin 13(T_TEMP1 (X-111,13) to transmission housing > 500k ok Internal wiring harness Pin 14( T_TEMP_GND (X-111,14) to transmission housing > 500k ok Internal wiring harness ➢ Remove vehicle connector from TCU, Disconnect transmission circular connector and check below resistance at transmission circular connector Measure Resistance (Ω) Component check Pin 13 (T_TEMP_1 (X-111,13) to Pin 14( T_TEMP_GND (X-111,14) 5160 +/- 500 ok TCU and external wiring harness Pin 13(T_TEMP_1 (X-111,13) to transmission housing > 500k ok TCU and external wiring harness Pin 14(T_TEMP_GND (X-111,14) to transmission housing > 500k ok TCU and external wiring harness
RkJQdWJsaXNoZXIy MTIwNTUz