NEXON NEW MCE-2 DCT BS VI DTC Troubleshooting Guide Version: 1.0 Date: 16-06-2023 Author: Akash/Rahul Page:98 of 645 Copyright ©TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. 28. P0715-86 Speed sensor measurement channel 3 : Signal Incorrect(input shaft) Overview: ISO Code P0715-86 Customer Symptom • Transmission fault lamp ON Fault Effects (On Vehicle) • Transmission fault lamp ON Lamp Status (If Any) Transmission fault lamp ON Service indication 0x2 Fault Detection Condition speed signal incorrect for >500ms Normal Operating Condition TCU does not detect signal incorrect from input shaft sensor Probable Trouble Area 1. Wiring loom towards the input shaft speed sensor. 2. Input shaft speed sensor. 3. Damaged TCU. Healing Condition The reaction is cleared at SW restart and driving if the detection is FALSE for more than 1000 ms Component Details: The Speed sensor - pump shaft/input shaft used in clutch actuation module in order to precisely control the torque transferred by both clutches. Preliminary Checks: 1) Loose/ Damaged Connections between Sensor and TCU. 2) Visually check sensor mounting& Air gap, proper tightening of mounting screws and any visible damage. 3) Check for damage or back out of pins at Clutch speed sensor connector and TCU connector. 4) Check correct fitment of ground cable connections on vehicle chassis. Trouble Shooting:- Step Checks IF YES IF NO 1. Check the wiring loom towards the turbine speed sensor. If damaged, replace the transmission wiring harness. Is there any rust/oxidation/pin back out observed on TCU PIN 18 (input shaft speed) in Transmission side 28 pole connecto and on pin 1 in Speed sensor input shaft connector? Clear the DTC and check if the DTC does not come back Go to step 2 2. If the fault is still active, replace the input shaft speed sensor. Clear the DTC and check if the DTC does not come back Go to step 3 3. Replace the TCU if the problem persists & flash the adaption data from the previous TCU. Clear the DTC and check if the DTC does not come back • Resistance Check ➢ Disconnect transmission side 28 pole connector (X-201) and check below resistance at (X-201) connector terminal
RkJQdWJsaXNoZXIy MTIwNTUz