NEXON NEW MCE-2 DCT BS VI DTC Troubleshooting Guide Version: 1.0 Date: 16-06-2023 Author: Akash/Rahul Page:139 of 645 Copyright ©TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. 40. P0775-13 Pressure control solenoid 2 (EDS 2): open circuit Overview: ISO Code P0775-13 Customer Symptom • Transmission fault lamp ON • Gearshift disable • Creep disable • Reverse and manual mode disable • Clutch open Fault Effects (On Vehicle) • Transmission fault lamp ON • Gearshift disable • Creep disable • Reverse and manual mode disable • Clutch open Lamp Status (If Any) Transmission fault lamp ON Service indication 0x2 Fault Detection Condition internal TCU error (FFT 1000ms) Normal Operating Condition TCU does not detect open circuit fault Probable Trouble Area 1. Transmission wiring loom for any damage. 2. Hydraulic unit & transmission oil. 3. TCU 4. EDS2 Clutch 2 cooling flow solenoid Healing Condition The reaction is cleared at SW restart if the detection is FALSE for more than 0 ms Component Details: Clutch actuator 1 & 2 mounted in hydraulic control unit and makes internal electrical contact with the TCU. EDS 2 = Clutch 2 (“Clutch”) cooling flow solenoid Preliminary Checks: 1) Loose/ Damaged Connections between Electro valve and TCU. 2) Loose/ Damaged mechanical fitments of TCU (TCU to valve body mounting). 3) Check correct fitment of ground cable connections on vehicle chassis. Trouble Shooting:- Step Checks IF YES IF NO 1. Check the transmission-wiring loom for any damage. Is there any rust/oxidation/pin back out observed on TCU PIN 25 & 1 in Transmission side 28 pole connector and on pin 3 &1 in circular connector? If damaged, replace the wiring loom. Go to step 2 2 If problem persists, replace the hydraulic unit & transmission oil. Perform all necessary transmission adaptions. Go to step 3 3 Replace the TCU if the problem persists & flash the adaption data from the previous TCU. Clear the DTC • Resistance Check Solenoids , Pressure sensors mounted on HCU should be checked for resistance if there is DTC triggered.
RkJQdWJsaXNoZXIy MTIwNTUz