NEXON NEW MCE-2 DCT BS VI DTC Troubleshooting Guide Version: 1.0 Date: 16-06-2023 Author: Akash/Rahul Page:196 of 645 Copyright ©TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. 54. P07E6-00 Stuck in park: Overview: ISO Code P07E6-00 Customer Symptom Transmission fault lamp ON Warning message no power to wheels stuck in Park Fault Effects (On Vehicle) Transmission Fault Lamp ON Lamp Status (If Any) Transmission fault lamp ON Service indication 0x1 Fault Detection Condition Drum cannot go out of LDS 0 for >1000ms Normal Operating Condition TCU does not detect any fault Probable Trouble Area 1. Transmission wiring loom (angle sensors + BLDC motor). 2. Drum angle sensor. 3. BLDC motor (coil resistance U-V / V-W / W-U = 46,6 mOhm, if value is deviating > 5 mOhm = NOK). Healing Condition The reaction is cleared at SW restart and driving if the detection is FALSE for more than 1000 ms Component Details: The parklock, will be able to lock the secondary shaft, when the park pawl moves inside the park gear (3). Just like the shift forks in the geartrain, the BLDC motor actuates the parklock through the drum. Preliminary Checks: 1) Loose/ Damaged Connections between Park lock and TCU. 2) Loose/ Damaged mechanical fitments of TCU (TCU to valve body mounting). 3) Check correct fitment of ground cable connections on vehicle chassis. Trouble Shooting:- Step Checks IF YES IF NO 1 Check freeze frame data, if vehicle speed during DTC >1km/h, communicate to driver that Requesting P while driving is not possible with transmission parkbrake, Clear the DTC Go to step 2 2 Check the transmission wiring loom (angle sensors + BLDC motor). If damaged, replace the transmission wiring harness. Clear the DTC and check if the DTC does not come back. Go to step 3 3 If DTC persists, Clear fault code + Perform homing procedure (by performing key cycle). Clear the DTC and check if the DTC does not come back. Go to step 4 4 If DTC persists, Check if drum angle sensor is fastened correcty, if not, check on sensor for damage, replace if necessary, tighten attachment bolts, Clear the DTC and check if the DTC does not come back. Go to step 5 5 If DTC persists, Check BLDC motor (coil resistance U-V / V-W / W-U = 46,6 mOhm, if value is deviating > 5 mOhm = NOK), If NOK, replace the BLDC motor. Clear the DTC and check if the DTC does not come back. • Resistance Check
RkJQdWJsaXNoZXIy MTIwNTUz