TATA BSVI Gasoline_Bifuel Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.9 Date: 24-01-2022 Prepared By: Veer K. Singh / Prudhvi B Varma Checked By: Yeshwant Jadhav Approved By: Sanjeev M. Document Part No: 2921 02 xxx xxxx Page: 637 of 1692 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P0604-42: Internal Control Module Random Access Memory (RAM) Error– General Memory Failure Overview: ISO Code P0604-42 Customer Symptom Vehicle would not start Fault Effects (On Vehicle) ECU Software reset happens Lamp Status (If Any) Sil lamp ON after 1 drive cycles Fault Detection Condition ECU internal failure Normal Operating Condition ECU Functions as per design intention Probable Trouble Area EMS ECU Healing Condition After 1 drive cycles Component Details: EMS ECU is an electronic controller which controls the Engine functionality by interfacing with various sensors, actuators and other controllers (via CAN) Preliminary Checks: 1. Check whether the EMS is receiving Battery supply and Ground 2. Check whether the Battery is healthy Trouble Shooting:- Step Checks IF YES IF NO 1. Check whether the EMS ECU is receiving supply and Ground Go to step 2 Rectify wiring harness connections as per schematic 2. Check whether the battery is healthy Go to step 3 Repair Battery 3 If fault still persists Replace EMS ECU Repeat above procedure for reconfirmation DTC’s confirmation:- After rectification, ensure the following points by referring engine parameters using TML diagnostic tool before handing over to customer. Replace EMS ECU and check whether the fault is rectified or not.
RkJQdWJsaXNoZXIy MTIwNTUz