Nexon_MCE2_7inch_Digital Instrument Cluster_DTC Trouble Shooting Data Version: 1.0 Date: 09-May-2023 Author: Suraj Patil / Rajesh Patil Page: 42 of 167 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Trouble Shooting: - DTC’s confirmation: - After rectification, ensure the following points before handing over the system to the customer. d) Fuel level bars shall do the 4sec welcome strategy on display when ignition key is ON. e) Fuel bars shall be displayed w.r.t the input resistance given in calibration table. f) Check also in vehicle driving condition & check the FLS input change in Bars. Turn ON Ignition. Connect the TML Diagnostic Tool. Check the status of DTC’s (Memorized/Current) Record the DTC & Clear DTC’s Turn Ignition OFF & ON Verify If DTC B1949 - 11 is present Is DTC B1949 -11 is Present? Check for continuity between Pin No.J1-4 (Batt.GND) & J112 (FLS input) of ECU side. Connector. Is Continuity Present? FLS input is Short Circuit to Ground. Rectify Fault at wiring Harness & wait for 20sec to recover the fault. Clear the DTC & In low-end variant vehicle check the function of Fuel Bars change on LCD display. & In high-end variant vehicle check the change in fuel level in Fuel bars. Clear the DTC from the ECU memory. Turn Ignition OFF & ON. In low-end variant check the function of Fuel level change on LCD display. & In high-end variant check the change of fuel level in Fuel bars. Stop Stop YES NO YES NO Stop
RkJQdWJsaXNoZXIy MTIwNTUz