Gravitas FATC Gen 3 DTC Troubleshooting Data Version: 1.0 Date: 15-July-2023 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Author: ERC Page: 182 of 301 Healing Condition 1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness short to ground)1) Connect the sensor connector firmly 2) If the values seen on the diagnostics tool in read ECU parameters is not getting updated then replace the sensor 3) If there is a continuity between the sensor signal and ground lines correct the wiring harness (wiring harness
RkJQdWJsaXNoZXIy MTIwNTUz