TATA BSVI Gasoline_Bifuel Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 2.6 Date: 5-10-2023 Prepared By: Pradip Shimpi Checked By: Yeshwant Jadhav Approved By: Sanjeev M. Document Part No: 2921 02 xxx xxxx Page: 1613 of 1720 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P0182-11: CNG rail temperature sensor circuit Low - Circuit Short to Ground Overview: ISO Code P0182-11 Customer Symptom MIL turns ON. Fault Effects (On Vehicle) It will effect drivability. Lamp Status (If Any) MIL ON after 1 drive cycle Fault Detection Condition This fault gets logged when Pin 226 CNG rail temperature line short to Ground Normal Operating Condition When the signal rate is within threshold Probable Trouble Area Wiring Harness, Rail Pressure and Temp. Sensor, ECU. Healing Condition After 3 drive cycles in CNG Fuel Mode Fault present deletion 1. Clear DTC Command form Scan tool. 2. Stack Over Flow. 3. 40 warm up cycles. 4. ECU flashing 5. ECU power fail Component Details: The CNG rail pressure and temperature sensor is a solid state pressure transducer having a NTC thermistor for measuring pressure and temperature of CNG. The pressure sensor is a semiconductor that varies electrical resistance when pressure is applied to its silicon chip. This sensor outputs the voltage in proportion to the internal fuel pressure. Preliminary Checks: 1. Check for any leakages in fuel lines 2. Check the connections continuity from Rail Pressure and Temp. Sensor to ECU pins.
RkJQdWJsaXNoZXIy MTIwNTUz