Part Replacement strategy IVI IC SVS Reflashing and Replacement spec Version: 0.7 Draft Released On: June 21, 2023 Copyright © Tata Motors Ltd. Page 25 of 34 Step 32. Service Reminder Requirements: Service Information Reset (3f00) routine has to be run. Interval and Pop up has to be written in DID 4628 as per below table with respect vehicle platform: In case, 4628 DID has written. Perform ECU reset 11 01. Service Interval Distance Service Interval Time Service Pop Distance Service Pop Time 15000 365 500 30 Step 33. Flashing Check: Verify the Odometer Value in the IC. I.e. Odometer value shall be same as noted in Step 1. Also, check the Telltale configuration as per respective VCs. Step 34. DTCs Check (Using TDS Tool): Connect Diagnostics Tool (Samtec/Vconnect) to OBD connector in IGN ON. Finally Click on Clear all DTCs in Scanning Information Window for all ECUs. Perform the Power Latch for 30 sec. (IGN OFF for 30 sec & Turn ON IGN). Read DTC for all ECUs & take necessary action based on DTCs present in Vehicle. Step 35. Mood lighting auto addressing (If applicable) Step 36. Auto addressing applicability Mood light module functions EOL Service Auto addressing service routine Y (First fitment) Y (Replacement) Note: Mood light feature and number of LED module will vary as per vehicle platform and variants Step 37. TML Service Tool Diagnostic - Pre-requisites: o HU should be in Ignition on state o Mood light feature and number of LED module configured using config file Step 38. TML Service Tool Diagnostic - Procedure: Operations Diagnostic Request Diagnostic Response Initiate mood light auto addressing 31 01 3D 09 71 01 3D 09
RkJQdWJsaXNoZXIy MTIwNTUz