5. To remove the Piston caliper, Apply air through the inlet port. 6. Carefully remove the boot piston from the caliper groove, ensure no dust and no damage in the boot groove while removing. 7. Carefully remove the seal from the caliper pot/cylinder groove, use proper tool. 8. After the end of the repair remove pedal blocker and follow the IVBAC bleeding procedure. 9. Deactivate “Assembly Mode”. Adjust proper brake fluid level. 10. NOTE when apply air the piston moves out of the pot/cylinder, have a suitable stopper to avoid piston fall off, exercise more care, ensure there is no scratch, dent, damage and a spiral mark in the cylinder bore diameter while removing. NOTE Do not use any metal part with sharp edge to remove the boot piston and ensure dust prevention in the cylinder after removing. NOTE Do not use any metal part with sharp edge, ensure no cut mark, scratch in the seal groove, and ensure no damage in the seal groove. Drain the excess oils from the caliper and clean the caliper thoroughly only with isopropyl alcohol BRAKES 46
RkJQdWJsaXNoZXIy MTIwNTUz