FRONT BRAKE PAD REMOVAL 3. 1. Jack the vehicle and remove wheel. 2. Loosen and remove the bottom sliding pin bolt. 3. Swing caliper as shown in figure. 4. Remove brake pads. ASSEMBLY: Follow reverse procedure to assemble brake pads. 1. After the end of the repair remove pedal blocker and follow the “IVBAC bleeding procedure”. 2. Deactivate “Assembly Mode”. 3. Adjust proper brake fluid level. NOTE Before removal of wheel please ensure 1. Ensure that Vehicle Battery is connected and the 46 pin IVBAC connector is connected to the IVBAC system. 2. Turn ON the vehicle ignition to “READY” state. 3. Plug in Tata Diagnostic Service (TDS) tool and activate “Assembly Mode” on IVBAC. 4. Turn Ignition OFF. 5. Use a pedal blocker to avoid draining of the Reservoir and the IVBAC. BRAKES 48
RkJQdWJsaXNoZXIy MTIwNTUz