15. Inspection of Sunroof Motor and Circuit Voltage Check 1) Checking is done with sunroof connector still connected. 2) Check voltage using a circuit tester. Terminal no. Wire color Signal spec Observation Condition Typical voltage 1 Ground for motor drive/Signal All Approx. 0 V 10 ACC signal input ACTIVE Hi ON： Battery voltage OFF：OPEN ACC “OFF” Approx. 0 V ACC “ON” Approx. 12 V 4 S/R SW input C ACTIVE Low ON：GND OFF：OPEN ACC “ON” “C” switch: Pressed Approx. 0 V ACC “ON” “C” switch: Not Pressed Approx. 12 V 5 S/R SW input A ACTIVE Low ON：GND OFF：OPEN ACC “ON” “A” switch: Pressed Approx. 0 V ACC “ON” “A” switch: Not Pressed Approx. 12 V 6 Power supply input for control unit and motor. All Approx. 12 V 3 S/R SW input ACTIVE Low ON：GND OFF：OPEN ACC “ON” “B” switch: Pressed Approx. 0 V ACC “ON” “B” switch: Not Pressed Approx. 12 V BODY 28
RkJQdWJsaXNoZXIy MTIwNTUz