16. Sunroof Motor Initialization 1) Set ignition “ON”, and press “CLOSE” side of sunroof switch to fully CLOSE Sunroof. 2) Keep pressing “CLOSE” side of sunroof switch for more than 10 seconds and then release it. 3)After Step 2, within 4 secs press “Close” side of sunroof switch and hold it. Check that sunroof opens fully and closes automatically, if not please start again from step 2. 4) Conduct slides open / close operation pressing “OPEN” / “CLOSE” of the sunroof switch just a little and check that manual functions work normally. 5) Conduct auto slide open / close operation pressing “OPEN” / “CLOSE” of the sunroof switch a bit longer and check that auto functions work normally. 6) Conduct anti-pinching function check. Anti-Pinching Function Check 1) Slide open sunroof fully. 2) Place hammer handle (2) wrapped with cloth (1) close to fully closed position. 3) Perform auto slide close of sunroof. 4) Check that sunroof glass & roll blind Assy reverses automatically to fully open position, from the position the hammer handle is lightly pinched. If a defect is found, initialize the sunroof motor. NOTE If an object is trapped during the sunroof motor initialization, the initialization is failed and the anti-pinching function is disabled. Do not pinch any object during the sunroof motor initialization. NOTE If the sunroof pinches the hard part of the hammer handle or the like which is not wrapped with cloth, the roof of the vehicle may be damaged. To avoid the roof damage, wrap hammer handle or the like with cloth for anti-pinching function test. BODY 29
RkJQdWJsaXNoZXIy MTIwNTUz