Re-Initialization and Teach process to be done on the vehicle. 17. The following steps are necessary to Initialize and Teach the module that has been previously Initialized and Taught. STE P ACTION START BUTTON DOOR & SIDE WINDOWS CONDITION 1 Get In the vehicle: In a no engine start condition get in the Vehicle. OFF Close or Open 2 Ignition “ON” and Check of all Doors and Side Windows Close Condition: - Press the Start Button once to “ON” the Ignition. If it were ok for TML to switch on the engine, it would be better to do this Step while switching on the engine instead of Ignition “ON” After Ignition “ON”, if any Doors or Side Windows are opened close them all. ON Close or Open >>> Close 3 Making GPA & ROLL BLIND ASM Close Condition: Check for the GPA(Glass Panel Assy) & ROLL BLIND ASM moving condition by using Close switch. Move GPA & ROLL BLIND ASM to Close position and release the hand from the Close switch. Confirm setting condition of GPA & ROLL BLIND ASM before going to next step. GPA & ROLL BLIND ASM condition must be matching vehicle body on Close position. ON Close 4 Re-initialization of reference position: - Press hold the Close switch until the glass panel assembly make a Quick one action.<Quick one action> - After about 10 sec with holding Close switch, the GPA & ROLL BLIND ASM shall move in quick one action. The GPA move to beyond close position side and comes back to close position momentarily After the GPA quick one action, ROLL BLIND ASM move to beyond close position side and comes back to close position momentarily After Quick one action of ROLL BLIND ASM, release the hand from the Close switch soon. < Caution > If quick one action is no happened during about 30sec, reinitialization has been failed. Start again from Beginning of Step 3 . ON Close BODY 30
RkJQdWJsaXNoZXIy MTIwNTUz