Smart Key and its Battery Replacement Procedure Title: Smart Key and its Battery Replacement Procedure Spec Num 2921 XX XXX A XXXX TBD Date: 22-Sep-2015 Version: 1.0 Page: 5 of 10 Prepared: Saichaitanya Checked: Nagnath Dhale Approved: Dinesh DG This specification is the exclusive property of Tata Motors Limited. Without their consent it may not be reproduced or given to third parties. The above specifications are subject to change and therefore suppliers are requested to refer the latest one. CONTROLLED COPY FOR RESTRICTED CIRCULATION © TATA MOTORS LTD. 1. Introduction 1.1. General The purpose of this document is to specify the Smart Key and its battery replacement procedure to be performed at service or dealer. It also specifies the Smart Key learning procedure at service or dealer. 1.2. Document Scope This document describes the Smart Key and its battery replacement procedure, Smart Key learning procedure. The TML service team is the intended audience for this document. 1.3. Terminologies The following table describes the terminologies used in this document. Term/ Abbreviation Description cm Centimeter (Unit of Length) DTC Diagnostics Trouble Code ESCL Electronic Steering Column Lock N Newton (Unit of Force) PEPS Passive Entry Passive Start SPD Spare Part Department TML TATA Motors Ltd. UID User Identification Device (or Smart Key) 1.1. Reference documents Note: The intended audience is requested to refer to the latest versions of the following documents. Agreement on these versions can be achieved by referencing in the following table a document listing all documents, which are relevant for the project SR. DOCUMENT DESCRIPTION 1 PEPS_Part Replacement Procedure_Vx.x PEPS Parts Replacement procedure strategy. 2 K__35450101_PEPS_UID Smart Key/ UID Battery mechanical details 3 2015-09-08_TATA_UID_Battery removal method Diagram on the UID battery replacement steps Table 1: Reference Documents
RkJQdWJsaXNoZXIy MTIwNTUz