TATA MOTORS LTD. V2X charging- Standard operating Procedure In Vehicle Ignition ON mode Project: Kanger3 LR Rev. V1.0 Date:24/07/23 Controlled copy for restricted circulation © TATA MOTORS LTD Format No: 1.Vehicle to load charging (V2L) a) Standard Operating procedure – V2L charging in Vehicle Ignition ON state 1. Turn ON the source vehicle ignition. Make sure to keep the vehicle in Ignition ON mode throughout the procedure. 2. Make sure to engage the park-brake/EPB. 3. Make sure to keep the vehicle and the V2L adaptor in dry environment/in shade. 4. Remove the caps & Connect the V2L adaptor gun to the source vehicle. 5. Connect external load to the V2L adaptor 3pin socket. Make sure that Electrical loads to be used for V2L charging are healthy/in good condition and ensure the relevant cables and plugs of loads are connected properly. Total power consumption of the loads used should be lesser than 3.3Kw and it is recommended to use the loads with Power factor greater than 0.85 In case of multiple loads, it is recommended to use extension box with MCB (16A) & with M Type plug and socket. 6. Press the V2X switch to start the 220V AC power supply.( check for the HMI). 7. Ensure safety precaution against the live 220VAC voltage in the V2L adaptor 8. Turn on the loads. 9. Check telltale indication in instrument cluster to ensure discharging is initiated/in progress.( check for the HMI) 10.Check for the telltale indication frequently when the V2L is in progress to ensure there is no interruption/fault. 11.To stop the V2L charging, first switch off the External loads and then Press V2X switch in the vehicle to stop the AC power supply and Go to step 14 .( check for the HMI) 12.V2L charging function will automatically stops if the source vehicle SOC goes below 30%(Configurable). In that case go to step 14.( check for the HMI & telltale indication on instrument cluster) 13. In case V2L charging gets interrupted from vehicle side due to any fault, , Press the Gun unlock fascia switch in vehicle and completely remove the gun while keeping the vehicles in Ignition ON and repeat from step 1 If the issue still remains, Press the Gun unlock fascia and completely remove the gun. After that vehicle should brought in to ignition OFF state. Keep the vehicles in Ignition OFF state for 30sec. Then repeat from Step 1.
RkJQdWJsaXNoZXIy MTIwNTUz