NEXON NEW MCE-2 DCT BS VI DTC Troubleshooting Guide Version: 1.0 Date: 16-06-2023 Author: Akash/Rahul Page:123 of 645 Copyright ©TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. ➢ Disconnect 28 pole TCU side connector and check below resistance at connector terminal Measure Resistance (Ω) Component check Pin 22 (T_VALVE_1_HS) to pin 24(T_VALVE_1_LS) 3 to 8 ok Internal, External wiring harness and Solenoid Pin 22(T_VALVE_1_HS ) to transmission housing > 100k ok Internal, External wiring harness and Solenoid Pin 24 (T_VALVE_1_LS to transmission housing) > 100k ok Internal, External wiring harness and Solenoid ➢ Remove vehicle connector from TCU, Disconnect transmission circular connector and check below resistance at transmission circular connector Measure Resistance (Ω) Component check Pin 15 (T_VALVE_1_HS) to transmission housing > 100k ok TCU and External wiring harness Pin 4 (T_VALVE_1_LS) to transmission housing > 100k ok TCU and External wiring harness • Continuity Check Check continuity between pins/terminals of External and Internal wiring harness connector for specific solenoid and pressure sensor for which the DTC is triggered DTC’s confirmation:- After rectification, clear all DTC’s and ensure the following points by referring TCU parameters using TML diagnostic tool before handing over to customer. • Drive the vehicle through all gears in both Automatic and Manual modes. • Ensure no DTC is active and Transmission Fault Lamp is OFF. Circuit Schematic Diagram:
RkJQdWJsaXNoZXIy MTIwNTUz