NEXON NEW MCE-2 DCT BS VI DTC Troubleshooting Guide Version: 1.0 Date: 16-06-2023 Author: Akash/Rahul Page:290 of 645 Copyright ©TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Pin 4 (T_VALVE_1_LS) to transmission housing > 100k ok TCU and External wiring harness • Continuity Check Check continuity between pins/terminals of External and Internal wiring harness connector for specific solenoid and pressure sensor for which the DTC is triggered. DTC’s confirmation:- After rectification, clear all DTC’s and ensure the following points by referring TCU parameters using TML diagnostic tool before handing over to customer. • Drive the vehicle through all gears in both Automatic and Manual modes. • Ensure no DTC is active and Transmission Fault Lamp is OFF. Circuit Schematic Diagram: Component Location & Image:-
RkJQdWJsaXNoZXIy MTIwNTUz