TPMS Part Replacement Procedure- NEXON MCE Title: TPMS System Part Replacement Procedure(NEXON MCE) Date: 18-Mar-20 Version 3.0 Page: 4 of 19 Prepared:Kapil M Checked: Awanish T Approved: Sanjeev M This specification is the exclusive property of Tata Motors Limited. Without their consent it may not be reproduced or given to third parties. The above specifications are subject to change and therefore suppliers are requested to refer the latest one. CONTROLLED COPY FOR RESTRICTED CIRCULATION © TATA MOTORS LTD. TABLE OF CONTENTS 1. Introduction ..............................................................................................................................................5 1.1. General ................................................................................................................................................. 5 1.2. Document Scope ................................................................................................................................... 5 1.3. Terminologies ........................................................................................................................................ 5 2. TPMS ECU Replacement Procedure .............................................................................................................7 2.1. Pre-checks / tasks to be done before replacing the ECU ............................................................................ 7 2.2. ECU replacement procedure ................................................................................................................... 7 2.3. TPMS ECU learning procedure .............................................................................................................. 10 3. TPMS Sensor Replacement Procedure using LF tool ...................................................................................14 3.1. Prerequisite for TPMS Sensor replacement: ........................................................................................... 14 3.2. Procedure for TPMS Sensor replacement: .............................................................................................. 14 4. Customer Requirement ............................................................................................................................15 4.1. If TPMS is replaced ............................................................................................................................... 15 4.2. If Sensor is replaced ............................................................................................................................. 15 5. Figures ....................................................................................................................................................16 6. Use case Vs. Routine applicability table ....................................................................................................18
RkJQdWJsaXNoZXIy MTIwNTUz