TPMS Part Replacement Procedure- NEXON MCE Title: TPMS System Part Replacement Procedure(NEXON MCE) Date: 18-Mar-20 Version 3.0 Page: 5 of 19 Prepared:Kapil M Checked: Awanish T Approved: Sanjeev M This specification is the exclusive property of Tata Motors Limited. Without their consent it may not be reproduced or given to third parties. The above specifications are subject to change and therefore suppliers are requested to refer the latest one. CONTROLLED COPY FOR RESTRICTED CIRCULATION © TATA MOTORS LTD. 1. Introduction 1.1. General The purpose of this document is to specify the TPMS ECU replacement procedure to be performed at service or dealer. It also specifies the TPMS learning, Sensor Replacement procedure at service or dealer. 1.2. Document Scope This document describes the TPMS ECU replacement procedure. The TML service team is the intended audience for this document. 1.3. Terminologies The following table describes the terminologies used in this document. Term/ Abbreviation Description DTC Diagnostics Trouble Code EOL End of Line ECU Electronic Control Unit IGN Ignition TML TATA Motors Ltd. OBD On board-Diagnostics TPMS Tire Pressure Monitoring System SPD Spare Part Department SSB Start Stop Button VIN Vehicle Identification Number FL Front Left FR Front Right RR Rear Right RL Rear Left SP Spare TDS Tata Diagnostic Tool
RkJQdWJsaXNoZXIy MTIwNTUz