TPMS Part Replacement Procedure- NEXON MCE Title: TPMS System Part Replacement Procedure(NEXON MCE) Date: 18-Mar-20 Version 3.0 Page: 13 of 19 Prepared:Kapil M Checked: Awanish T Approved: Sanjeev M This specification is the exclusive property of Tata Motors Limited. Without their consent it may not be reproduced or given to third parties. The above specifications are subject to change and therefore suppliers are requested to refer the latest one. CONTROLLED COPY FOR RESTRICTED CIRCULATION © TATA MOTORS LTD. Go to Rear right (RR) tire and start removing tire air (air release must be high like 1.2 psi/sec) until hazard flashes and horn beeps once for short time. Stop removing the air and RR tire is learnt successfully. Go to rear left (RL) tire and start removing tire air (air release must be high like 1.2 psi/sec) until hazard flashes and horn beeps once for short time. Stop removing the air and RL tire is learnt successfully. Go to spare tire (SP) and start removing tire air (air release must be high like 1.2 psi/sec) until hazard flashes and horn beeps twice. Stop removing air and Spare tire is learnt successfully. TPMS learning is completed successfully. Turn the ignition OFF. Turn ON Ignition. Fill all the tires to the OEM recommended pressure values. Drive Vehicle with 40 kmph speed for 5 minutes. All Tire value should be updated on IPC. Warning: 1. It is always necessary to follow the above sequence only for air removal from tires while learning. Failing to do so can wrongly learn the TPMS and the indications will be misleading. 2. During learning, TPMS tell-tale and TPMS HMI display on your vehicle Instrument cluster will also show the learning status apart from hazard flashing and horn beeps. 3. If TPMS has successfully entered into learning mode, TPMS tell-tale and tire alert symbol will glow continuously. The tire for which learning is being done will blink continuously and the tire for which learning is successfully completed will glow continuously. Note: 1. Learning has Time limit of 300 seconds (5 min). After this ECU will come out of Routine automatically. 2. While learning using Routine, Operator needs to ensure that no other TPMS Tire sensor is near to the learning vehicle by 10 meter. 3. After ECU learning fill tire pressure to recommended tire pressure only. 4. Operator can learn one tire at a time by selecting respective tire learning routine.
RkJQdWJsaXNoZXIy MTIwNTUz