IPC Specific Diagnostic Specification for Nexon MCE 2 CNG 4” Digital Cluster program Step 6: Flashing Status: Software flashing progress bar will be displayed once it is started. Wait until Software flashing is completed & it displays Software Flashing Completed. Step 7: If Flashing Failed: Repeat the Steps from 2 to 6. Step 8: After Flashing Completes: Turn OFF the Ignition for 30 Seconds. After 30 Seconds turn ON the Ignition and provide the Clear All DTC Command. Step 9: Flashing Check: Verify the Odometer Value in the IC. I.e. Odometer value shall be same as noted in Step 1. Also, check the Telltale configuration as per respective VCs. Step 10: DTCs Check (Using TDS Tool): Finally Click on Clear all DTCs in Scanning Information Window for all ECUs. Perform the Power Latch for 30 sec. (IGN OFF for 30 sec & Turn ON IGN). Read DTC for all ECUs & take necessary action based on DTCs present in Vehicle. Note: 1. If IC Software is flashed on Existing IC on Vehicle, then Do Not Perform the ECU Online Replacement using TDS Tool. 2. If IC is taken from Stock OR from Supplier & it is fitted on vehicle then first Perform the ECU Online Replacement using TDS Tool & then go for the IC Software flashing. 3. For online replacement, do not update the Odometer value using DID. Please keep this option in write data tool tab only. TITLE: IPC Specific Diagnostic Specification for Nexon MCE 2 CNG 4” Digital Cluster program Document number: TBD Date: 22-08-2024 Version: V1.0 Page: 17 of 17 Prepared: Suraj Shivsharan Checked: Jagadish Ghodake Approved: Sanjay Jaisingh This specification is the exclusive property of Tata Motors Limited. Without their consent it may not be reproduced or given to third parties. The above specifications are subject to change and therefore suppliers are requested to refer the latest one. CONTROLLED COPY FOR RESTRICTED CIRCULATION © TATA MOTORS LTD.
RkJQdWJsaXNoZXIy MTIwNTUz