2. GLASS PANEL A ASSY (GPA) REMOVAL Remove the Seal acoustic. (Refer Removal 1. procedure of seal acoustic as mentioned above) 2. Bring Glass panel A (GPA) in close condition & Roll blind ASM in open condition. 3. Remove the Four COMBI SCREW M5X10-0.5 With Washer from Both Sides.(LH & RH) on Glass panel A (GPA). 4. lift and remove GLASS ASSY A.(GPA) ASSEMBLY For Assembly, Follow the reverse procedure of removal. 1. Adjust Glass Assy A (GPA) orientation to make Glass mark to Rear RH side. 2. Adjust height of Glass Assy A (GPA) with Roof. 3. Centering of Glass Assy A (GPA) in the Roof opening. 4. Tighten 4 Screw’s on SLIDING ROOF GLASS ASSY A (GPA) with torque 7 ± 0.7 N-m. 5. Initialize ROOF ASSY, OUETR SLIDING. (Refer Re-initializing & Teach Procedure) 6. Check the operation for all Glass Assy A (GPA) positioning. (Tilt up / Down, Open / Close) 7. Water Leak check in Glass Assy A (GPA) close condition. CAUTION Take care no scratches on sunroof body & its attachment parts while doing attachment or detachment. NOTE Do not squeeze the tip of the hose and sprinkle water on the sealing area. Always use hand gloves. BODY 16
RkJQdWJsaXNoZXIy MTIwNTUz