1878 / 5157
PVBU Applications: Procedure for EMS ECU
Replacement
PVBU Applications: Procedure for EMS ECU replacement
Doc No: 2921 XX XXXX XXXX
Date: 19 Feb 2016
Revision: 0.1
Page 13 of 16
Prepared: Priti Pandey
Checked: Mithipati Prasad
Approved: G.S.Raju/ Vilasini
Prabhu
This document contains confidential information which is exclusive property of TML. The contents of this
document shall not be reproduced, or conveyed, or given to third parties in any manner without the consent
of TML.
Step 2
: Once flashing is successful perform Injector learning using Tata Diagnostic tool.
Note*:
In place of ZICA , OSPREY project name will be displayed. To be update din next version.
Step 3
: After Injector coding learning, prepare for SPCS update using diagnostic tool where pre-conditions
are:
i)
Vehicle Ignition shall be turned ON.
ii)
Gear should be in neutral position
iii)
Clutch should not be pressed
iv)
Accelerator pedal should be in release condition.
v)
Vehicle speed should be maintained 0 kmph.